Chrome Plating Section
MECHAS ORIGINAL PROJECT
ABSTRACT & GALLERY ARTWORK
NEW AGE FASHION DESIGNS
Fertility Goddess
C & R MODELS
CUSTOM FURNITURE
Main
Saturday
Mar272010

Robotics Servo Controllers

This controller board has 8 standard servo outputs and 2 Open collector transistor outputs, 3 buffered inputs and a direct processor connection, these 6 non-servo digital inputs and outputs can be used in the scripted program control of your robotic device. Pogramming and setup is acomplished using a PC with a USB port. The cable end must be a mini USB B connector for programming.

 

 

  • SconScript V2.5 Firmware
  • 512 KB Off-Processor memory
  • Eight Buffered servo outputs
  • 3 Buffered digital inputs
  • 2 Open collector outputs
  • 1 Flexable I/O
  • 5.5 - 12 Volt operation
  • 10 Mips processor
  • Small 2.2 X 1.8 inch size
  • USB Interface
  • Seperate servo power
  • Screw Terminals for Power
  • Supplied with PScon
  • Schematic diagram included
  • Quality components
  • Assembled and tested
  • Power source not included
  •  

     

     

     

     

     

    References (2)

    References allow you to track sources for this article, as well as articles that were written in response to this article.

    Reader Comments

    There are no comments for this journal entry. To create a new comment, use the form below.

    PostPost a New Comment

    Enter your information below to add a new comment.

    My response is on my own website »
    Author Email (optional):
    Author URL (optional):
    Post:
     
    Some HTML allowed: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <code> <em> <i> <strike> <strong>